How To Put On Jumper Cables

Subscribe for more service tip. Attach the other positive clamp to the good.

How To Jump Start Your Car

The safest order to attach the jumper cables is as follows.

How to put on jumper cables. This jumper cable needs to be securely attached as well. Connect the other red. Make sure its securely connected.

If playback doesnt begin shortly try restarting your device. Make sure that the clamp is firmly connected. Click to see full answer.

Next get out your jumper cables and connect one of the red clamps to the positive post of the dead battery. First place the negative or black jumper cable on the body of the starters motor. Attach one black jumper cable clamp to the negative terminal of the working live cars battery.

Next place the positive or red jumper cable to the post on the starter solenoid that leads to the motor. Clamp the positive red or yellow cable to the positive terminal of the weak battery. Attach the jumper cable to the most secure attachment point you can find on the cars permanent battery cables.

Make sure the other end doesnt touch any part of the cars engine or body or you could get a dangerous spark. This will cause sparks to fly and can easily damage a battery not to mention the car itself and the possibility of injury to yourself. Clamp the matching end of the same cable to the positive post on the working battery.

Straighten the jumper cables so there is no room for knots or ties in the either cable. This can be as small as the head of a bolt located nearby. Attach the other end of the same cable the second red jumper cable clamp to the positive terminal on the working live car battery.

Videos you watch may be added to the TVs watch history and influence TV recommendations. Connect one of the black clamps to the negative - post of the good battery. Attach one red jumper cable clamp to the positive terminal on the dead battery.

Attach one of the jumper cables positive red clamps to the dead batterys positive terminal marked with a -- its often covered with a red cap. A short circuit can occur if either of the cables touches the connector on the opposite. How to Hook Up the Jumper Cables.

DIY demonstration of how to attach jumper cables to a dead car battery as well as a demonstration of how to jump start a car. Attach one red jumper cable clamp to the positive terminal on the dead battery. How to jump-start a car steps.

With both cars off and in park connect the jumper cables in the following order. Connect the negative terminal to metal on the engine for the correct way on how to attach jumper cables. Attach the black cable to the - side of the good battery.

Connect one red clamp to the positive battery post of the dead battery. Step 4 - Open the Hood and Locate the Batteries. Attach the other end of the black cable to a section of unpainted metal on the dead car.

Step 3 - Prepare Your Jumper Cables. The safest order to attach the jumper cables is as follows. This guide shows you How To Start A Car With Jumper CablesWatch This and Other Related films here.

Also make sure the clamps do not come in contact with each other as this could cause a short circuit. To avoid this cancel and sign in to. Attach the other end of the same cable the second red jumper cable clamp to the positive terminal on the working live car battery.

The golden rule when connecting two batteries together is to avoid a short circuit.

Discover The Easy Way To Jump Start A Car