How To Make A Bee Trap

The two tails of the cord can be used to tie around the tree or post to keep the trap in place. The bees will be drawn into the trap by the smell of the honey but they wont be able to get out.

Upcycle A Wine Bottle Into A Wasp Catcher Diy Network Blog Made Remade Diy

To start make sure to have an empty 2-liter bottle a utility blade and a stapler.

How to make a bee trap. Distribute the soap throughout the bait by stirring it with a utensil. Simply pour a bit of honey in it then put the cap back on and punch a small bee-sized hole in the side of the jug. Then divide the distance between the center hole and the lip to find and mark the spots that youll use to screw the jar to the trap.

Once inside the box the bees fly toward the light. Since the bees prefer to use an existing hole these traps provide the hole they are seeking. Use a 12-inch metal bit to make the center hole larger.

Pound a nail or lag screw into the support tree post building etcand loop the knot in the cord over the nail. Leave the other holes as is. To ensure bees that enter your trap dont make it out alive add a tablespoon 15 ml of liquid laundry soap to your bait.

Materials Needed for DIY Carpenter Bee Trap 1X8 Piece of Wood your choice just remember these. You may also build a bee trap by using a plastic jug. DIY Carpenter Bee Trap Directions.

Drill holes and add cord to make a hanging trap. Consider adding a drop of honey or some sugar water to the mason jar to make. Find the center of your lid and mark it.

What is Required to Make a Pine Wood Best Box Bee Trap. Gather a wooden post along with a few other supplies then make tunnels for the bees to enter the trap. Drill a ½ hole through the center of the post length wise.

Build the trap away from the area where the carpenter bees are to avoid agitating them. Then check back every day as the trap rids your home of the unwanted pests. Use a drill bit large enough to allow your cord to pass through.

Cut the post to the desired height. Drill two holes an inch 25 cm below the top of the trap with each hole on opposite sides of the bottle. The soap will poison and kill all bees that ingest it.

Anywhere between 5 8 will work. The Trap Is Set The trap is a simple wooden box with 12 holes drilled in all 4 sides at an upward angle. Distribute the soap throughout the bait by stirring it with a utensil.

Hanging the trap is simple. Poison bees with laundry soap. The trap should tip forward and rest against the support at the bottom.

Feed one end apiece of a length of cord into the two holes holes. To ensure bees that enter your trap dont make it out alive add a tablespoon 15 ml of liquid laundry soap to your bait. Cut the bottle all the way around about 5 inches from the top.

Install a Mason jar or another transparent object to hold the bees. Flip the piece you just cut off place it in the other half of the bottle and staple it in place. Now get to workRated Reds Ashla Taylor shows two quick and easy ways to make a carpenter bee trap___Check this outhttpratedredtvyoutube___For al.

The soap will poison and kill all bees that ingest it. Use a punch to make your holes. The blade can be substituted with a knife or scissors just be careful.

On three sides of the post measure out a ½ hole that is 3 from the top and centered.

How To Build A Carpenter Bee Trap