Refinishing Stained Woodwork

There will probably be some worn chip and damaged areas that will need to be touched up with stain prior to varnishing. Work in small areas.

Touch Up Wood Furniture Quick Refinish Resurface Woodwork Cabinet Table Trim Stain Restore Youtube

After the stain has dried its time for the first finishing coat.

Refinishing stained woodwork. Remember you put the stain on unfinished wood so you need to seal the stain to protect it. Wherever some of the old finish has disappeared and the wood has become water-stained start by sanding off whatever remains of the old finish with 120-grit sandpaper. I use a finishing pad or a fine steel wool and gently buff the area to be re-stained.

Finish by wiping the woodwork with a clean cloth to remove the excess stain. See below for a shopping list and toolsSUBSCRIBE to This Old House. It also helps to begin with a pre-stain conditioner.

After the stain dries for a few days you can add a coat of furniture wax or wipe-on poly to really liven up the old wood. Before refinishing a piece of furniture youll need to clean it first. Then apply the Minwax stain that best matches the surrounding trim.

Reapply the stain to reach the desired depth of color. Secondly look over the furniture to determine if there are any dents dings or repairs that may require additional attention in the refinishing process. Apply multiple thin layers rather than one or two heavy layers as this helps you control the coloration.

Seal or finish the stained wood. Let the table dry according to the directions on the stains packaging. Ensure that you apply a decent amount of stain as you brush it on so that it really penetrates down into the timber.

Brush the stain liberally onto the table following the natural direction of the grain. Allow the stain to be absorbed and to dry before continuing. Then dry it with a cleaning cloth.

Wipe down the wood with a microfiber tack cloth to remove any dust. I used this gray stain to counteract the orange tones of the wood. Use dish soap warm water and a sponge to remove any dirt or debris.

Wood finishing expert Bruce Johnson shares tips for refinishing new and old furniture. Once applied to get the best streak-free finish possible gently wipe over the applied stain using a clean cotton rag wiping in the same direction that you applied the stain with the grain as this will then remove any streaking. Allow the stain to sit for 10-15 seconds and then wipe off with.

When the wood is dry dip a rag into the stain and wipe it over the wood. Seal the wood object by applying a. Let the stain soak into the wood for just a few minutes before wiping it off with a clean towel.

Remove any hardware that you are afraid you will get stain on or damage while sanding the surface. Bare spots and scratches will pick up the stain. 12 rows Protect For Long Lasting Beauty.

Dont use standard tack cloths that contain potential finish repelling oils. Following these three steps will ensure that the Helmsman you apply will adhere to and protect both the old finish and the underlying wood. This clear penetrating liquid prevents the stain from being blotchy in some areas and thin in other areas.

It will bubble as you brush it on. Apply wood stain in the direction of the wood. Wearing personal protection apply stain to the wood furniture with a rag or brush.

While wood stains add color and bring out the beauty of. Stain the wood with your chosen wood stain once again using short even strokes with a brush. Open and stir your polyurethane then brush a coat on.

Make sure to remove all of the flaking polyurethane and expose the stained surface. Finally protect both stain and.

How To Refinish Wood Trim So It Looks Great Pickled Barrel