Replacing Tub Spout

If playback doesnt begin shortly try. If the nipple is too short to grab with a wrench use an internal pipe wrench 10.

Bathtub Spout Is 3 4 Stub Out And Universal Replacement Kits Won T Work Suggestions Plumbing

But there is the problem of size here too.

Replacing tub spout. The last time I replaced a tub diverter spout I bought 2 spouts one that would work on threaded nipples. It provides a decorative cover for the pipe stub delivering water to the bathtub and it directs the water away from the wall where it could cause damageOur spout was more or less failing at both functions. Insert a large screwdriver or the handle of a wood hammer into spout using the tool as a lever to rotate the spout in a counterclockwise direction.

Now twist the spout counter-clockwise. Before replacing your tub spout you will need to determine which type of tub spout you have and what kind you will need to replace it. CC Slip Fit - Requires a 532 Hex wrench.

The spout works fine until the plunger thing is pulled to direct the water to the shower head. The end of the wall pipe must fit into a rubber gasket near the front of the spout. Repair Leaking Tub Spout Diverter Pull in Shower Mode - YouTube.

A tub spout does two things. Just insert the handle into the opening of the Tub Spout for leverage. Unthread the tub spout counter-clockwise to remove.

Slide the spout back onto the wall when youre finished repairing or cleaning it and reinsert the screw that holds the spout on the wall. Loosen the Hex screw until the tub spout slides off. Slip spouts are slightly less difficult to remove and replace no threads to clean no pipe joint compound etc.

If your Tub Spout has a set screw holding it in place be sure to remove that prior to rotating the Spout off. Replace a setscrew tub spout by holding the spout in place and screwing in the setscrew underneath the spout. This will loosen and the spout and it should now be easy for you to remove.

When the shower head is on the connection to the spout seems to leak a little Were the tub spout pipe connects to the tub spout fixture - not inside the wall. If your Tub Spout is hard to remove you may need to use the end of a hammer or large wrench to help loosen while turning. The gasket seals the connection between the pipe and the spout.

Take the nipple measurement and the original bathtub spout to a plumbing supply or home improvement store to find a replacement using the measurement and. Im thinking that I need some tephlon tape at the connection. While it is possible to replace a spout without shutting off the water supplywith just the faucet turned offits always best to turn off the water supply at a shut-off valve when making any plumbing repair.

If you plan on reusing the spout protect it with a couple of wraps of duct tape where the wrench will be placed. How to replace a tub spout Unscrew the old nipple Unscrew the old nipple with a pipe wrench. Check to ensure the spout is properly aligned with the tub when installing the.

Wrap the tape tightly around the nipple before replacing the spout. Turn off the water at the tubshower shut-off valve or the main water supply shut-off valve. Unthread and remove the spout.

I recently replaced the tub spout in our master bath. Hold the screwdriver in one hand and the spout in the other. Tips for installing a universal tub diverter spout.

Use the Allen wrench to tighten the screw so the spout. Diverter style that allows you to send the flow of the water to either the tub spout or the shower with a diverter right on the tub spout and non-diverter style that flows only from the tub spout into the tub. There are two basic types of tub spouts.

Bathtub Spout Replacement Youtube