Motion Light Installation

Direct the motion detector at the zone you want to be covered. Keep the bulbs as far away from the motion.

How To Install A Security Motion Detector Light Fixture

The LED light is solar powered with auto light and motion sensor motions.

Motion light installation. Strip the redwire in both light fixtures. Failure to do so may increase the RISK OF PERSONAL INJURY PROPERTY DAMAGE FIRE AND DEATH. Use a voltage meter to test the wires to ensure the power is OFF.

Connect the redwire of the controlling master fixture to the red and blackwires of the controlled slave fixture. Install and use so fixture failures do not cause a hazard and use only in. The light automatically comes on when it senses motion in the yard.

Install Motion Lights When working with electricity always. Turn OFF electricity at the main fuse box or the circuit breaker box that controls the power to the fixture or the room youre working on. The sensor is built into the light so you want to install the floodlight where it can pick up motion easily.

To install this feature. While mounting the light to the box position the. If playback doesnt begin shortly try restarting your device.

Motion Light Installation - YouTube. The light is powered by bright LEDs that will last for years and save energy and the motion detector can sense motion up to 70 feet away making it ideal for those with larger yards. INSTALLATION INSTRUCTIONS - MOTION SENSOR WARNING.

If you do not have electrical wires going to the outside you must install the wiring before you can install the motion-activated light. Up next in 8. Connect your motion sensor to normal control gears LED drivers or ballasts.

After that run the motion sensor wires through the rubber gasket and splice them with wire nuts. Total fixture ratings must not exceed 500 Watts 41 A. With the auto on the light will turn on automatically at dusk and then turn off at sunrise.

Fixtures must be grounded and installed in accordance with the National Electrical Code and all local codes. Motion sensors have the ability to switch on a light when movement is detected and switch off after a set period of time when no motion is detected. The first step to installing your outdoor security lights is to shut off the power at the service panel and remove the existing floodlight.

Plus its marketed as easy to install by DIYers with just three steps. Wiring Diagram 2 When wiring to control another motion sensing light fixture Master Slave. Screw in the light bulbs and point them to the area you want lit.

This way if you have a path you want to highlight during the dusk and nighttime hours you can have this helpful light ready to go. Connect all white wires together.

How To Choose And Install A Motion Sensor Light Diy Family Handyman