How To Change Toilet

DONT force the toilet down by tightening the nuts on the toilet boltsthat might crack the porcelain base. Turn off the toilets water supply valve by turning the valve handle clockwise until it stops.

How To Install A Toilet Diy Family Handyman

Flush the toilet to empty the cistern.

How to change toilet. Sit on the toilet to squish the wax ring Seat the toilet firmly When you set the toilet in place you have to squish the wax ring until the toilet settles to the floor. Disconnect the water feed from the inlet valve. Step-by-step toilet installation guide 1.

Ad Emergency Plumber Job Vacancies in United Kingdom. If it continues to leak take the tank back off and be sure the gasket is seated correctly. If you have different type of toilet consult with your local independent home improvement retailer for further advice.

Drain the Toilet. If its leaking tighten the bolts a little more. Disconnect your water supply.

Ad Emergency Plumber Job Vacancies in United Kingdom. Remove your existing toilet. Isolate the water supply to the toilet either locally or at the mains.

Set the toilet over the anchor bolts and sit on the toilet rocking it back and forth to seat the wax ring. Straddle the toilet bowl and lift using your legs and not your back. Most of this video will demonstrate how to replace the wax ring a critical part of replacing the toilet.

Remove the water disconnect the tank install the new toilet and connect the water lines. These step-by-step instructions show how to replace a toilet and include the following steps. Toilets are heavy so get some help.

In just a few minutes you can update the look of your toilet and bat. Hook up the water supply and slowly turn on the water. Contact Us To Get It Fixed.

Contact Us To Get It Fixed. Got Some Blocked Drains - At Home Or In The Office. Got Some Blocked Drains - At Home Or In The Office.

Mop out the remaining water from the tank and the bowl with a large sponge. Check for leaks around the supply line and the gasket base. Remove any fixings and gently pull the toilet.

Flush the toilet to empty the tank. Remove the tank lid and set it aside in a safe place. Flush the toilet a few times and check around the base.

Replacing a toilet handle is a simple project that even a novice DIYer can take care of. The wax ring creates a seal between the toilet bowl and the drain in the floor.

How To Replace A Toilet Diy Master Bathroom Remodel